How to fix a Shark NAVIGATOR NV46 that is not picking up dirt?
If your Shark Vacuum Cleaner isn't picking up dirt, start by checking the filters and clean them if necessary, following the rinsing and drying instructions. Also, empty the dust cup if it's full. Inspect the hose and its connections for any blockages and clear them. If the dust cup is empty and the attachment inlets are clear, check for other blockages.
Why is there no suction in my Shark Vacuum Cleaner?
If you're experiencing restricted airflow or weak suction with your Shark Vacuum Cleaner, you should check the filters and clean them if needed, following the rinsing and drying instructions. Make sure to empty the dust cup if it's full. Inspect the hose, connections, nozzles, and accessories for blockages and clear them. Close the suction release on the hose to increase suction power. If the dust cup is empty and attachment inlets are clear, check for other blockages.
What to do if my Shark NAVIGATOR NV46 Vacuum Cleaner turns off by itself?
If your Shark Vacuum Cleaner turns off on its own, it might be overheating, which triggers the motor protective thermostat. To restart it: 1. Move the On/Off switch to the “O” (Off) position. 2. Unplug the vacuum. 3. Empty the dust cup and clean the filters. 4. Check for blockages in the hose, accessories, and inlet openings. 5. Allow the unit to cool for at least 45 minutes. 6. Plug in the vacuum. 7. Turn the On/Off switch to the “I” (On) position to restart the vacuum. If it still doesn't start, further assistance is needed.
What to do if the motorized floor brush on my Shark NAVIGATOR NV46 is jammed?
If the motorized floor brush on your Shark Vacuum Cleaner has become jammed or shut off, immediately turn off and unplug the vacuum. Disconnect the nozzle and remove any blockage before reconnecting and turning the vacuum back on.
How to stop my Shark Vacuum Cleaner from lifting scatter rugs?
If your Shark Vacuum Cleaner is lifting scatter rugs, it's because the suction is too powerful. When vacuuming scatter-type rugs or those with delicately sewn edges, open the suction release on the hose to decrease the suction power.
General| Type | Upright |
|---|---|
| Cord Length | 25 feet |
| Voltage | 120V |
| Filtration | HEPA |
| Accessories/Included Tools | Crevice Tool, Dusting Brush |
| Power Source | Corded |
| Model | NV46 Series |
Safety points for electrical use, cords, plug, and general handling of the appliance.
Step-by-step instructions for assembling the vacuum cleaner correctly.
Explains power switch settings for different floor types and the suction release feature.
Procedures for removing and emptying the dust cup, with options for quick empty or allergy sufferers.
Detailed steps for rinsing and air-drying the foam and felt pre-motor filters.
Instructions for washing and air-drying the post-motor filter.
Addresses issues like poor suction, brushroll problems, and vacuum shutdown with solutions.
Steps to follow if the vacuum's motor overheats and automatically shuts off.
To Next Page