6 TOLL FREE: 1-800-798-7398
Using the Vacuum
Your Shark
®
Navigator
™
Upright
Vacuum can be used to clean bare
floors or carpets – with the click of
a switch.
Stand the vacuum into the upright
position.
Plug in the vacuum.
1 Start with the Power Switch in
the “O" - Off position.
2 Place your foot on the Floor
Power Nozzle and pull handle
towards you.
3 Set the Power Switch to desired
cleaning setting.
4 When cleaning carpets:
Ensure you have pulled the
handle towards you and select
the “II" - Brushroll On position
to agitate the carpet fibers for
deeper cleaning performance.
When cleaning bare floors:
Select the "I" - On position for
suction only cleaning to avoid
scattering dirt while cleaning.
5 Due to the huge suction
power of this vacuum, it
may become necessary to
adjust the suction release
on the hose. If the vacuum
is difficult to push or pull or
if it is lifting up area rugs,
adjust the suction release by
opening or closing the valve
at the top end of the hose.
IMPORTANT:
Your Brushroll Indicator Light
will illuminate solid green when
the brushroll is on, or solid red if
there is a blockage. This feature
is designed to protect your
Lifetime Belt that powers your
brushroll. See Checking for
Blockages on page 11.
NOTE: The height of your power
nozzle has been optimized
for easy pushing and superior
cleaning on all floor types, so
there is no need to make any
height adjustments as you
transition to different floor &
carpet types.
IMPORTANT: To protect your
carpets, the brushroll will only
turn on when you have pulled
the handle back towards you and
released the Floor Power Nozzle.
OFF
Bare Floors /
Tools
Carpets
Power Switch Settings
Suction Release
Release suction for
easier push and pull
on high pile carpets
and area rugs.
To Next Page
Loading...
Need help?
General
