sharkclean.comsharkclean.com
NOTE: All accessories are compatible with both the wand and the handle.NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), set to MAX suction and use setting II, Carpet.
WHOLE-HOME CLEANING
CLEANING MODES
Press the Power/Surface switch
to the appropriate floor setting,
then step on the nozzle and tilt the
handle back to engage the brushroll.
Select surface setting:
O O
I Hard Floor
For bare floors and area rugs. The
brushroll will spin slowly in this mode.
II Carpet
For carpets. The brushroll will spin
quickly in this mode.
To engage the brushrolls, turn on the
power, step on the floor nozzle, and
tilt the handle back.
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as intended.
Solid Red: There is a jam in the brushroll area. Turn your vacuum o, unplug from the wall and
remove any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn your vacuum o and wait a
minimum of 60 minutes for it to cool down.
See Troubleshooting section for more information.
Press the Wand Release button
and pull up on the wand to
detach it from the pod.
Press the Handle Release button
and pull up on the handle to
detach it from the wand.
UPRIGHT MODE
POWER/SURFACE SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—WANDABOVE-FLOOR—HANDLE
Handle
WHOLE-HOME CLEANING
SETTINGS
BRUSHROLL INDICATOR LIGHT
The Suction Control Slider located on
the handle allows you to adjust the
suction depending on the floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
SUCTION CONTROL
To Next Page
Loading...
Need help?
General
