sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove Dust Cup, slide up tabs on both sides
of dust cup handle. Tilt dust cup forward, then
lift to remove.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.
Press lower release button to open bottom of
dust cup.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush debris o the screen.
RINSE HEPA FILTER
EVERY YEAR
To Remove HEPA Filter, remove dust cup, tilt
Filter Door and firmly pull it o. Press tab at
top of HEPA Filter and pull out filter.
To reinstall, insert top part of HEPA filter first.
Then, replace filter door by inserting the top
part with tabs first then pushing in bottom
until it clicks into place.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electricparts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance. Empty
the dust cup each time you vacuum and periodically during cleaning, when debris
in the dust cup reaches the MAX fill line.
Foam
Felt
Filter
Door
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFFK560
Replacement
HEPA Filter
XHEPA560
Follow the previous instructions for removing filters. The Pre-Motor Filter should be replaced every
2.5 years. The HEPA Filter should be replaced every 3 years.
REPLACING FILTERS
To Next Page
Loading...
Need help?
General
