9
DUST-AWAY
™
HARD FLOOR
ATTACHMENT &
CLEANING PADS
INSTRUCTIONS
MICROFIBRE PAD
1 Slip two of the tabs between the suction nozzle and the duster base and attach them to the front fasteners on the base. Then pull the other two tabs tightly around
to the back fasteners on the base. For best results, ensure that the pad is flat against the bottom surface and secured tightly.
2 Use the Dust-Away
™
to clean dry bare floor surfaces. Do not use to clean damp floors or wet/sticky messes. Only use pads provided by Shark
®
, which are designed
to work with the Dust-Away
™
attachment.
3 Wash the pads separately with warm water either in the washing machine or by hand using liquid detergent.
Do not use bleach or fabric softeners as they may damage or leave a coating that will reduce the cleaning performance of the pads.
Tumble dry low or line dry to extend the life of the microfibre fabric.
For best floor cleaning results, we recommend replacing your microfibre pads every 3-4 months following normal use.
To Next Page
Loading...
Need help?
General
