Shark NV44 - Vacuum Setup and Handling; Attaching Super Stretch Hose; Vacuum Storage; Carrying the Vacuum

5
www.sharkclean.com
10 To carry the vacuum:
With the unit in the standing
position, lift by the Dust Cup
Assembly Handle (carry handle).
CAUTION: When lifting or
carrying, DO NOT press Dust
Cup Assembly release button.
8 Attach the Super Stretch Hose:
a) Snap hose into swivel
connector
b) Route under anti-tip hook
c) Route over upper hose
holder
d) Press securely onto cleaning
wand
IMPORTANT:
To prevent vacuum from
tipping, secure hose under the
anti-tip hose hook.
9 When storing your vacuum,
wind cord around the two cord
holders and secure with cord
clip:
 •QuickCordreleaseatthe
top of the unit – place in the
upright position.
 •Secondholdernearthe
base – turn until it is pointing
down.
 Toreleasethecord,turntheQuick
Cord release to the left or right.
IMPORTANT:
For suction to reach the
MotorizedFloorBrush,the
Cleaning Wand and Super
Stretch Hose must be attached
securely on the vacuum body.
a
c
8 9
b
d
NV44_26_IB_E_130124_1.indd 5 13-01-24 11:36 AM