A
Motorized Floor Nozzle
B
Wand
C
Handle
D
Pet Multi-Tool
ASSEMB LY
WHAT’S INSIDE MAINTENANCE
NV751_QSG_170329
QUICK START GUIDE
POWERED
LIF T-AWAY ®
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
Insert wand into
motorized floor nozzle.
Press top dust-
cup release latch
to access dust
screen and remove
built-up debris
asrequired.
Use a coin to
open the 3
locks on the
bottom of the
floornozzle.
Remove any
string, carpet
fibers, or hair
that may be
wrapped around
the brushroll.
A portion of the base
is hinged for better
access to the brushroll
and exposure to the
airway. To reassemble,
replace base by lining
it up along the front
nozzle. Rotate closed
and lock the 3 locks.
Pre-Motor (foam and felt):
With the dust cup removed, take out and rinse the foam and
felt filters with water.
Post-Motor (HEPA):
To access the HEPA filter, reach under the grill and pull the
Filter Access latch to remove the grill. Remove and rinse the
HEPA filter.
Place pod onto wand and
slide down to connect.
Connect hose to back of
pod, pressing until it clicks
into place. Store accessories
on the posts on the pod.
Insert handle into wand.
1
(Click)
2
(Click)
3
(Click)
4
(Click)
Empty dust cup after each use
TIP:
Wash filters every
3 months to keep
the suction strong.
Rinse filters and allow
to air-dry completely.
Tap loose dirt from
foam filters as needed
between washes.
Easy brushroll maintenance
Cleaning Filters
Pull up on
dust cup
release latch
and lift dust
cup o pod.
Hold dust cup over a
trash bin and press the
empty-release latch
on the bottom.
HEPA
Felt filter
Foam filter
Filter
E
Hard Floor Hero™ Attachment
F
Crevice Tool
G
Pet Power Brush
B
C
A
F G
ED
To Next Page
Need help?
General
