Shark Rocket NV480 Series User Manual

7 8
1-800-798-7398 sharkclean.com
ASSEMBLING
YOUR VACUUM
1 Place the floor nozzle on
a level surface. Align the
opening on the Lift-Away
®
pod with the tube on the
floor nozzle, then lower the
pod onto the tube until it
clicks into place.
2 Insert the extension wand
into the tube on the top of
the pod. Press down until
the wand clicks into place.
3 Insert handle into top of
extension wand. Press
down until wand clicks into
place. Insert hose into the
connector on the back of
the pod. Press down until
hose clicks into place.
4 Insert tools onto the
accessory posts.
5 To remove the accessory
holder, first take out the
dust cup, then pull the tab
on the holder away from
the pod. To replace the
holder, align the pins into
the hinge on the back of
the pod and clip the holder
back into place.
STEP 1 STEP 2 STEP 5STEP 3 STEP 4
DID YOU KNOW?
The Shark
®
Rocket
®
Professional
is an ultra-light upright, weighing
less than 14 pounds without the
cord.
TIP: Use cord clip located
on the back of wand to
hold cord in place while
vacuuming.
TIP: To store your
vacuum, wrap cord
around cord hooks.
CLICK!
CLICK!
CLICK!
CLICK!

Shark Rocket NV480 Series Specifications

General

Style	upright vacuums
Color	copper/gray, multi
Floor Type	all floors
Cord Length	360 feet
Filter	other
Washable Filter	yes
Brush Roll Shut-Off	yes
Bagless	yes
?leaning Area	12 inches
Voltage	120 volts
Current	6 amperes

Weight and Dimensions

Length	9.5 inches
Height	45 inches
Width	12 inches
Net Weight	13 pounds