sharkclean.comsharkclean.com
PRE-MOTOR FILTER POST-MOTOR FILTER
Press the wand release button to disconnect
the handheld vacuum from the wand.
To remove the dust cup from the handheld vac-
uum, press the Dust Cup Release button near
the handheld vacuum nozzle. Tilt the dust cup
and lift o to remove.
To empty dust and debris, hold the dust cup over
the trash, then slide the Lid Release slider forward.
To empty the Dust Cup while it is attached
to the handheld vacuum, position the dust
cup over a trash receptacle and slide the
CleanTouch™ Lid Release slider forward.
To clean the interior of the dust cup, rinse it
with water. Place it on its side to air-dry for at
least 24 hours before reinstalling.
EMPTYING THE DUST CUP
REMOVING AND CLEANING THE DUST CUP
MAINTAINING YOUR VACUUM
1
1
2
2
Press the dust cup release button and
remove the dust cup. Pull the foam and felt
filters out of the back of the dust cup.
Remove the dust cup. Pull the post-motor
filter out of the handheld vacuum.
MAINTAINING YOUR VACUUM
CLEANING THE FILTERS
Regularly rinse and replace the filters to maintain your vacuum’s suction power.
To clean filters, rinse them with water only. Allow all filters to air-dry completely for at least
24 hours before reinstalling to prevent liquid from being drawn into electricparts.
Clean the pre-motor filters at least once a month and post-motor filter at least once a year.
Tap o loose dirt between washes when needed. More frequent cleaning may sometimes be
necessary with heavy use.
IMPORTANT: DO NOT use soap when cleaning the filters. Use water only.
Pre-Motor Foam and Felt Filter Kit
Post-Motor HEPA Filter
To Next Page
Loading...
Need help?
General
