1. Using a coin, turn locks counterclockwise to
open, then lift o cover to access Brushroll.
2. Clear airway of blockages.
3. Replace cover, pressing down firmly on all sides,
including along the front, before turning locks
clockwise to close.
CLEANER HEAD MAINTENANCE
MAINTENANCE
CHECKING FOR BLOCKAGES
CHECK HANDHELD
CHECK CLEANER HEAD
CHECK WAND
MAINTENANCE
Remove the wand from the handheld vacuum and
check all dust cup intake openings.
Detach the wand, then use the edge of a coin to open
the three locks on the bottom of the cleaner head.
Remove the cover, then tilt back the neck of the
cleaner head and check the opening for blockages.
Replace cover, pressing down firmly on all sides
before turning locks clockwise to close.
Zero-M™ Technology actively removes hair wrap from your brushroll while you vacuum. If you run over
a hard or sharp object or notice a noise change while vacuuming, check for blockages or objects caught
in the brushroll.
Detach the wand and check it for blockages.
NOTE: If any hair is wrapped around the brushroll, continue cleaning, using High Pile Carpet mode on a bare floor surface, or
a low-pile carpet or area rug. This will allow Zero-M technology to remove the hair wrap and send it to the dust cup. If some
fibers remain wrapped around the brushroll after continued use, carefully remove the debris from the brushroll.
To Next Page
Loading...
Need help?
General
