Remove dust cup to access foam
and felt filters. Next, press down
top of filter door. Tilt filter door
and lift out. Press tab at top of
HEPA filter and pull away from
the base of the vacuum.
To reinstall, insert HEPA filter into
unit and replace the filter door.
Wash filters every 3 months to keep the suction strong.
Rinse filters with water only and allow to air-dry completely.
Tap loose dirt from foam filters as needed between washes.
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
ASSEMB LY
A
Vacuum Pod
B
Handle & Hose
C
Wand
D
Hose Clip
E
5.5" Crevice Tool
F
Pet Power Brush
WHAT’S INSIDE EMPTYING THE DUST CUP
MAINTENANCE
QUICK START GUIDE
Empty the dust cup after each use.
clean
A
B
C
F
D
E
Brushroll access
Unlock Open Cover Clear Intake
Use a coin to turn locks, then lift
cover open. Clear the debris intake.
(Click)
(Click)
(Click)
(Click)
NOTE: For proper operation, ensure all parts
are firmly CLICKED into place.
HEPA
Filter
Filter
Door
Foam
Felt
NV255_QSG_MP_Mv7
PET PLUS
To Next Page
Need help?
General
