6sharkclean.com
ASSEMBLING YOUR
STEAM MOP
WARNING: ALWAYS
make sure the Steam
Mop is UNPLUGGED
when not in use.
NEVER fill the
Steam Mop when it
is plugged into an
electrical outlet.
Unplug from the
electrical outlet and
allow the unit to cool
before you fill the
water tank, or attach
or remove the mop
head. Make sure you
add only water to
the tank. Chemicals
or cleaning solutions
(including vinegar)
may damage the
Steam Mop and could
be unsafe for you and
your family.
1 Align the mop handle and mop pole so the arrow
symbols inside them face forward. Insert either end
of the pole into the handle until it clicks securely
into place.
2 Align the assembled steam mop pole and the
steam mop body so their arrow symbols both face
forward. Insert the pole into the top of the mop
body, sliding it in until it clicks into place.
3 Place the Dirt Grip® cleaning pad on the floor with
the quick fastener strips facing up. Align the mop
head directly over the pad, then press the mop
head down onto the pad. The quick fastener strips
will secure the pad to the mop head.
STEP 1
STEP 2
STEP 3
To Next Page
Loading...
Need help?
General
