8sharkclean.eu
Intelligent Steam Control
®
The Shark
®
Klik n' Flip Smartronic Deluxe Steam Pocket
®
Mop has 3 unique Intelligent Steam Control settings so
you can use the right amount of steam for the cleaning task at hand. See below for tips on when to use each setting.
SETTING IDEAL FOR THESE SEALED
SURFACES
RECOMMENDED USAGE
LOW
Laminate
Hardwood
Marble
Cleaning delicate surfaces
Light cleaning and dusting
Loosening and lifting light dirt
MED
Hardwood
Marble
Tile
Stone
Cleaning sealed surfaces and large areas
Basic, everyday cleaning
Removing spots and smaller messes
Cleaning moderate and heavy traffic areas
HI
Hardwood
Marble
Tile
Stone
Deep cleaning and cleaning hard-to-clean surfaces
Tough cleaning and removing stuck-on messes and stains
Deep cleaning heavy traffic areas
Cutting through heavy dirt and grime
Steam Blaster
™
For an extra burst of steam, you can use the Steam Blaster feature in LOW, MED and HI.
Follow the instructions found on the “Using your Steam Pocket
®
Mop” page.
TO SANITIZE* WITH THE STEAM MOP USING THE KLIK N' FLIP MOP HEAD AND THE DIRT GRIP
™
PAD:
1 Attach a clean Dirt Grip pad to the Klik N' Flip Mop Head.
2 Plug in the unit and press the Steam Control Button to select the HI Setting.
3 Wait 30 seconds for the unit to begin producing steam.
4 Start mopping on an appropriate sealed hard-floor surface with a forward and backward motion. After three minutes, your
unit is ready to be used to sanitize.
5 Using a forward and backward motion, move the unit over the area you seek to sanitize. Slowly repeat at least 3 times.
* Sanitization studies were conducted under controlled test conditions. Household conditions and results may vary. With
Klik n' Flip Mop in HI mode only when used with Steam Mop. Not in Steam Blaster mod
e.
To Next Page
Loading...
Need help?
General
