17 180800 862 0453 sharkclean.eu
ORDERING ADDITIONAL ACCESSORIES TROUBLESHOOTING GUIDE
ACCESSORY
Intelli-Mop™ Head
Great for all-purpose cleaning. Get an extra boost for
tough stains from the Steam Blaster
™
, and clean twice
the area with the hands-free two-sided pad.
Dirt Grip™ Pad
Double-sided pad. Easy, hands-free installation and
removal. Washable and reusable.
Triangle Scrubber Head
Triangle shape is perfect for cleaning corners and
hard-to-reach areas. Equipped with a Steam Blaster™
to help loosen stains and stuck on dirt.
Triangle Scrubber Pad
Ideal for cleaning corners and other hard-to-reach
spaces. Easy to install and remove.
WARNING: To reduce the risk of shock and unintended operation,
turn o power and unplug unit before servicing.
The Steam Cleaner isn’t producing any steam.
• The Steam Cleaner should be securely plugged into an electrical socket.
Check your fuse or circuit breaker or try a dierent socket.
• Make sure the water tank is full, the unit is plugged in, and the light around
the Steam Control Button is solid.
• If the lights below the Steam Control Button are not illuminated, try a
dierent electrical socket.
• If the lights below the Steam Control Button are blinking, press the Steam
Control Button to select a Steam setting.
• If the lights below the Steam Control Button are solid, wait 30 seconds for
the unit to warm up.
• If after following the above steps the Steam Cleaner still does not produce
any steam, contact Customer Service at 0800 862 0453 or sharkclean.eu
The Steam Cleaner is producing intermittent steam.
• This is normal—for more consistent steam select the HI setting.
• Also make sure the water tank is full.
I can’t select a Steam Setting.
• Make sure the Steam Cleaner is plugged in and the lights below the Steam
Control Button are solid.
• If your Steam Cleaner is producing steam but the lights below the Steam
Control Button are not lit, call customer service at 0800 862 0453.
I am getting streaky/cloudy floors.
• The Dirt Grip™ pad might be dirty. If it is, flip it over to the clean side
or change it entirely. If you washed the Dirt Grip™ pad with powdered
detergent, then it could be damaged and require replacement.
• This could also be an indication of soap or grease residue that has
accumulated on the floor. As the Steam Cleaner uses only a small amount of
water, it may not be enough to rinse o the accumulation of residue that the
steam is bringing to the surface. We suggest rinsing the floor with nothing
but water, letting it dry, and then steam clean again with a clean Dirt Grip™
pad. One or more rinses will generally remove the residue.
• A more stubborn case may require you to rinse the floor with a mix of one
part vinegar and two parts water* (but DO NOT put vinegar or any other
cleaner into the Steam Cleaner’s water tank.)
• *Please consult your flooring manufacturer’s care and maintenance
instructions before applying any cleaning products or solutions
including vinegar.