11 120800 862 0453 sharkclean.eu
INTELLIGENT STEAM CONTROL
The Shark
Steam
Cleaner has 3 unique
Intelligent Steam
Control settings so
you can use the right
amount of steam for
the cleaning task at
hand.
See below for
tips on when to
use each setting.
For a full list of what
is included with your
Steam Cleaner, please
refer to box’s top panel.
ABOVE-FLOOR CLEANING
TO SANITIZE* WITH THE STEAM CLEANER USING THE
INTELLI-MOP
™
HEAD AND THE DIRT GRIP
™
PAD:
1 Attach a clean Dirt Grip™ pad to the mop head.
2 Plug in the unit and press the Steam Control Button
to select the HI Setting.
3 Wait 30 seconds for the unit to begin producing
steam.
4 Start mopping on an appropriate sealed hard floor
surface with a forward and backward motion. After
three minutes, your unit is ready to be used to sanitize.
5 Using a forward and backward motion, move the
unit over the area you seek to sanitize. Repeat at
least 5 times.
Setting Ideal For These
Sealed Surfaces
Recommended
Usage
TOOLS
Laminate
Hardwood
Marble
Cleaning delicate
surfaces.
Light cleaning and
dusting.
Loosening and
lifting light dirt.
LO
Hardwood
Marble
Tile
Stone
Cleaning most
surfaces and large
areas.
Basic, everyday
cleaning.
Removing spots and
smaller messes.
Cleaning moderate
and heavy-trac
areas.
HI
Hardwood
Marble
Tile
Stone
Deep-cleaning and
cleaning hard-to-
clean surfaces.
Tough cleaning and
removing stuck-on
messes and stains.
Deep-cleaning
heavy-trac areas.
Cutting through
heavy dirt
and grime.
Sanitizing* floors.
Steam
Blaster
™
For an extra burst of steam, you can
use the Steam Blaster™ feature in LO or
HI. Follow the instructions found on the
“Using your Steam Cleaner” page.
The Shark® Floor and Handheld Steam
Cleaner is designed to clean surfaces that can
withstand high heat and moisture. Do not use
on unsealed wood surfaces (especially antique
wood furniture), unglazed ceramic tile, painted
surfaces, or surfaces that have been treated
with wax, oils, varnishes, or shellac. The sheen
may be removed by the heat, steam, and
friction of the cleaning accessories. It is always
recommended to test an isolated area of the
surface to be cleaned before proceeding.
We also recommend you check the use and
care instructions from the surface manufacturer.
When cleaning finished wood surfaces, use
broad, continuous strokes. To prevent surface
damage, avoid focusing steam or allowing the
cleaning accessories to remain stationary in any
one spot.
• Remove the Handheld Steamer by pressing
on the release button and pulling away from
the cradle.Be careful to NOT press the steam
trigger as you remove the handheld steamer.
(Fig. 12).
• The Handheld Steamer is automatically set
to TOOLS mode. Squeeze the steam trigger
to activate steam. You may select other
steam modes depending on the accessory
and the use.
• With all attachments, control Steam better by
using 3-to-5-second bursts of the trigger. This will
allow you to steam longer and with more control.
Fig. 12
* Sanitisation studies
were conducted
under controlled
test conditions.
Household conditions
and results may vary.
With Klik ‘n’ Flip®
Mop in HI mode
only when used with
Steam Cleaner.
Not in Steam
Blaster™ mode.
To Next Page
Loading...
Need help?
General
