7 80800 862 0453 sharkclean.eu
ASSEMBLING YOUR STEAM CLEANER
1 Screw the mop
handle into the
Steam Cleaner
body (screwdriver
not included)
(Fig. 1).
2 Slide the Klik ‘n’ Flip®
Head connector into
the Steam Cleaner
body. Push until you
hear it click securely
into place. (Fig. 1)
To detach the Klik
‘n’ Flip
mop head,
press the release
button on the front
of the unit above
the head connection
(Fig. 1) and slide o.
3 To attach the Dirt Grip™ pad,
spread the pad on the floor with
the pockets face up. Lift the
mop and center the Klik ‘n’ Flip®
Head above the pad, then press
down on the release buttons on
the neck of the Steam Cleaner
head (Fig. 2a). Both sides of the
Klik ‘n’ Flip® Head will drop open
(Fig. 2b). Slip the Klik ‘n’ Flip®
Head’s four corner tabs into the
four corner pockets of the pad
(Fig. 3 and Fig. 4). Gently press
one side of the Klik ‘n’ Flip® Head
to the floor until that side clicks
into place (Fig. 5). Repeat on the
other side (Fig. 6).
4 Open the water tank cap
(Fig. 7), fill the tank with water,
then replace and tighten the cap.
Use the filling flask and pour
water into the tank (Fig. 8).
Do not overfill. Replace
the cap on the water tank.
WARNING:
Always make sure
the Steam Cleaner
is UNPLUGGED
when not in use.
Never fill the Steam
Cleaner or attach
the mop head
when the Steam
Cleaner is plugged
into an electrical
socket. To prolong
the life of your
Steam Cleaner, we
recommend using
distilled water.
Make sure you add
only water to the
tank. Chemicals or
cleaning solutions
(including vinegar)
may damage the
Steam Cleaner
and could be
unsafe for you
and your family.
Fig. 1
Fig. 5
Fig. 6Fig. 4
Fig. 4
Fig. 3
Fig. 2b
Fig. 2a
Fig. 7
Fig. 8
To Next Page
Loading...
Need help?
General
