IMPORTANT: Do not use on unsealed wood
or unglazed ceramic floors. On surfaces that
have been treated with wax or some no wax
floors, the sheen may be removed by the heat
and steam action. It is always recommended to
test an isolated area of the surface to be cleaned
before proceeding. We recommend that you
check the use and care instructions from the
floor manufacturer.
4 Turn the water tank cap counter clockwise and
remove from the tank. (Fig. 4)
Use the filling flask to pour water into the tank.
Do not fill past the fill line on the water tank.
(Fig. 5)
5 After filling the tank, replace the water tank
cap by placing back on the tank and turning it
clockwise until tight.
Getting Started - cont.
fig. 4
fig. 5
Calcium and mineral deposits can build up and
impact the performance of your steam mop
over time. To extend the life of your product we
recommend that you use distilled water.
SM200_11_IB_ENG_120608_1.indd 4 12-06-08 4:12 PM
To Next Page
Loading...
Need help?
General
