Sharp 13N-M100 - Parent Control (V-CHIP Operation Continued); Changing V-CHIP Secret Number; Additional Mode (Download)

18
• To change the V-CHIP BLOCK setting. (Secret No. is registered.)
1 Repeat steps 1 to 3 of [1] MPAA RATING, then “INPUT SECRET
No.” will be displayed.
2 Enter the 4-digit SECRET No. using the REMOTE KEYPAD
and the V-CHIP select mode will be displayed. Repeat
configuration of the V-CHIP BLOCK.
• If you intend to change or forget your Secret No., clear the original Secret No. and set
up a new one.
1 Repeat steps 1 to 3 of [1] MPAA RATING, or 1 to 2 of [To cancel
the V-CHIP BLOCK screen while V-CHIP BLOCK has been
activated], then “INPUT SECRET No.” will be displayed.
2 Press and hold both VOL (+) and CH DOWN ( 9 ) on the TV set
simultaneously until the message “INPUT SECRET No.”
disappears.
3 Press MENU two times to exit.
[3] ADDITIONAL MODE (DOWNLOAD)
There will be an additional new rating system. In that case, please set up as follows.
Subsequently the new rating system will set up automatically.
1 Repeat steps 1 to 3 of [1] MPAA RATING.
2 Press CH UP ( 8 ) or DOWN ( 9 ) to move the “ ” mark to
“DOWNLOAD”.
3 Press VOL (+) or (–) to “DOWNLOAD : ON”.
4 Repeat pressing MENU to return exit.
(On the Set)
VOL (+)/CHANNEL
DOWN (
99
99
9 ) buttons
Parent Control (V-CHIP Operation Continued)
– – –
–
NI PUT SECRET No .
∗ ∗ ∗
∗
NI PUT SECRET No .
MP AA
TV GUIDELINES
AD : OFF
OFF
DO
W NLO
STATUS :
MP AA
TV GUIDELINES
AD : ON
OFF
DO
W NLO
STATUS :
MENU
VOL +
CH
17-19 13N-M100/150[B].p65e 31/07/2000, 11:51 PM18