Sharp 27N S50 - Activating V-CHIP Block Function

20
[3] ACTIVATE ON TO TURN ON V-CHIP BLOCK
1 Press CH UP ( 8 ) or DOWN ( 9 ) to move the “ ” mark to
“STATUS”, then press
VOL (+) or (–) to activate the V-CHIP
BLOCK. (If STATUS is OFF, V-CHIP BLOCK will not be operated.)
2 Press MENU , then “INPUT SECRET No.” will be displayed.
3 Enter the 4-digit SECRET No. using the REMOTE KEYPAD .
4 Press MENU and SECRET No. is registered.
L To cancel the V-CHIP BLOCK screen while V-CHIP BLOCK has been activated.
1 “V-CHIP HAS BEEN ACTIVATED” will be displayed if you watch
the program with Program Rating data the same as you configured.
NOTE:
•“V-CHIP HAS BEEN ACTIVATED” will not be displayed if STATUS is not configured to “ON”.
2 Press MENU , then “INPUT SECRET No.” will be displayed.
3 Enter the 4-digit SECRET No. using the REMOTE KEYPAD , then
V-CHIP BLOCK will temporarily be canceled. If the wrong SECRET
No. is chosen, “SECRET No. IS INCORRECT” will be displayed.
Input the SECRET No. again in this case.
NOTE:
• If you change Power from OFF to ON, then V-CHIP BLOCK will be activated ON again.
→
Parent Control (V-CHIP Operation Continued)
19-25 27N-S50 6/1/00, 11:43 AM20