EasyManuals Logo

Sharp 32JW-74EES User Manual

Sharp 32JW-74EES
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
32JW-74E
Colour Adjustments
The following adjustments should only be carried out when the CRT, IC850, IC851
or IC852 are replaced.
G2, Cut Off and Gain Adjustments
1. Follow the procedure below to set the G2
1.1 Tune the set to the output of a signal generator (cross hatch pattern).
1.2 In the user menu, set contrast to 80/100 and brightness to 40/100.
1.3 Connect the oscilloscope to the RED cathode (pin 8 of CRT socket)
and adjust G2 to read 150V on the sensor pulse as in the drawing:
Vertical Bow
Adjust the Vertical Bow so that the picture is centred.
The effect of this adjustment is shown in figure 11.
When the volume up button is pressed, the vertical bow changes to left.
When the volume down button is pressed, the vertical bow changes to right.
Press the stand-by button on the remote control to store.
Vertical Amplitude
Adjust the Vertical Amplitude so that 8% over-scan is achieved.
The effect of this adjustment is shown in figure 12.
When the volume up button is pressed, the vertical size of the picture increases.
When the volume down button is pressed, the vertical size of the picture decreases.
Press the stand-by button on the remote control to store.
S Correction
Adjust the S Correction so that the picture symmetrical between the top, centre and bottom.
The effect of this adjustment is shown in figure 13.
When the volume up button is pressed, the top and bottom scanning decreases and the
centre scanning increases.
When the volume down button is pressed the top and bottom scanning increases and the
centre scanning decreases.
Press the stand-by button on the remote control to store.
Vertical Shift
Adjust the Vertical Shift so that the picture is centred.
The effect of this adjustment is shown in figure 14.
When the volume up button is pressed, the picture moves up.
When the volume down button is pressed, the picture moves down.
Press the stand-by button on the remote control to store.
Figure 14
Figure 11
Figure 12
Figure 13
150 V
CH1 gnd
Figure 15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp 32JW-74EES and is the answer not in the manual?

Sharp 32JW-74EES Specifications

General IconGeneral
BrandSharp
Model32JW-74EES
CategoryTV
LanguageEnglish

Related product manuals