Sharp 8M-B120C - Dealing with Problems

EN 11
ENGLISHDEUTSCH ESPAÑOLITALIANO FRANÇAISРУССКИЙPOLSKI
Dealing with Problems
When Operation Becomes Unavailable
• When strong external noise (excessive static electricity, electrical surge of power supply due to lightening, etc.)
occurs or when wrong operation is performed, the Monitor may not be able to accept any operation.
• If this is the case, press the power button on the main body to turn off the power, turn on the power again, and then
perform the operation again.
• If the operation is still unavailable, hold down the power button on the main body for at least five seconds. After the
Monitor is shut off, wait for approximately one minute. Then press the power button again to turn on the power and
perform the operation again. Even after these button operations above, setting items such as menu are retained.
NOTE
• Since data loading is performed immediately after turning on the power, it will take a while until images are displayed on the
screen.
Checking System Status and Software Version
• You can check the status of the Monitor by confirming the software version or system status.
3
1
Press MENU and select Setup using
p
/
q
/
t
/
u
buttons, and confirm with
ENTER.
2
Press
p
/
q
/
t
/
u
to select
(Information) > Identification, and
confirm with ENTER.
3
Select “Start” and confirm with ENTER.
• The system status will be displayed.