ENGLISH
EN-11
Be sure to disconnect the power cord from
the wall outlet or turn off the circuit breaker
before performing any maintenance.
CLEANING THE FILTERS
1
Turn off the unit.
2
Remove the fi lters.
Lift the open panel.
Pull the air fi lters down to remove them.
3
Clean the fi lters.
• Use a vacuum cleaner to remove dust. If the
fi lters are dirty, wash them with warm water
and a mild detergent. Dry fi lters in the shade
before reinstalling.
4
Reinstall the fi lters and close the open
panel.
CLEANING THE UNIT AND THE REMOTE
CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It can
cause electrical shock or equipment damage.
• Do not use hot water, thinner, abrasive powders or
strong solvents.
MAINTENANCE AFTER AIR CONDITIONER
SEASON
1
Dry the inside of the indoor unit thor-
oughly by taking the following steps.
(High end models)
Run the unit in the SELF CLEAN operation mode.
(Standard models)
Run the unit in the COOL mode with temperature
setting of 30°C.
2
Stop the operation and unplug the unit.
• Turn off the circuit breaker, if you have one
exclusively for the air conditioner.
3
Clean the fi lters, then reinstall them.
MAINTENANCE BEFORE AIR CONDITION-
ER SEASON
1
Make sure that the air fi lters are not dirty.
2
Make sure that nothing obstructs the air
inlet or outlet.
MAINTENANCE
SELF CLEAN operation will reduce
the growth of mold fungus with
Plasmacluster ions and dry inside
of the unit. Utilize the operation
at seasonal change over terms or
every 4 months.
1
Press the SELF CLEAN button
when the unit is not operating.
• The remote control will display “ ”.
• The blue PLASMACLUSTER lamp
(
) will light up.
• The unit will stop operation after 90
minutes.
TO CANCEL
Press the SELF CLEAN button
again.
• The blue PLASMACLUSTER lamp
(
) will turn off.
SELF CLEAN OPERATION
1
(For High end models only)
AH-XP18SHV-1 (A889)_EN.indd EN-11AH-XP18SHV-1 (A889)_EN.indd EN-11 11/8/2559 BE 2:36 PM11/8/2559 BE 2:36 PM
To Next Page
Loading...
Need help?
General
