30
Useful Features (Continued)
■
Changing V-CHIP BLOCK settings
Repeat steps 1 to 3 of Setting V-CHIP on page 29,
then “INPUT SECRET NO.” will be displayed.
Input the 4-digit secret number by using Channel
Select; the V-CHIP select mode will be displayed.
Set the V-CHIP BLOCK again.
M P A A
T V G U I D E L I N E S
C A N . E N G L I S H R A T I N G S
C A N . F R E N C H R A T I N G S
S T A T U S
■
Changing or clearing the SECRET NUMBER
If you forget the secret number, clear the secret number
as follows.
Upper control panel of the main unit
Repeat steps 1 to 3 of Setting V-CHIP on page 29,
or
1 and 2 of Canceling the V-CHIP BLOCK screen
while V-CHIP BLOCK is activated, then “INPUT
SECRET NO.” will be displayed.
Press and hold both CH (
) and VOL (
+
) on the main
unit simultaneously until the message “INPUT SECRET
NO.” blinks.
Press MENU to exit.
■
Activating V-CHIP BLOCK
●
Setting STATUS
You can activate V-CHIP BLOCK after setting V-CHIP.
Repeat steps 1 to 4 of Setting V-CHIP on page 29.
Press
'
/
"
to select “STATUS”, and press ENTER
.
M P A A
T V G U I D E L I N E S
C A N . E N G L I S H R A T I N G S
C A N . F R E N C H R A T I N G S
S T A T U S
Press
'
/
"
to select “ON”, and press ENTER
.
A
• If “STATUS” is set to “OFF”, V-CHIP BLOCK will not be
activated.
Press MENU to exit.
■
Canceling
the V-CHIP BLOCK screen while
V-CHIP BLOCK is activated
“V-CHIP HAS BEEN ACTIVATED” appears if you watch
a program with the same Program Rating data you
configured.
V
–
C H I P H A S B E E N A C T I V A T E D
T V
–
1 4
D L S V
A
• “V-CHIP HAS BEEN ACTIVATED” will not be displayed if
“STATUS” is set to “OFF”.
Press MENU to display “INPUT SECRET NO.”.
Input the 4-digit secret number by using Channel
Select; V-CHIP BLOCK is temporarily canceled. If
you input an incorrect secret number, “SECRET NO.
IS INCORRECT.” is displayed. In this case, input the
correct secret number.
2
1
3
4
1
2
3
1
2
1
2
3
LC-20D30U_E_book.indb 30 2005/12/15 11:27:15
To Next Page
Loading...
