3
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
1
Confi rm the screws supplied with the TV.
5
5
Screw driver
Screw
Soft cushion
Screws (
m
4)
(used in step 3)
2
Insert the stand base to the stand post on the
bottom of the TV. (
1
)
3
Insert and tighten the 4 screws into the 4 holes
on the bottom of the stand base. (
2
)
NOTE
• To detach the stand, perform the steps in reverse order.
Antenna connection
Connecting the antenna cable
To enjoy a clearer picture, use an outdoor antenna.
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
Room antenna terminal
(75-ohm type)
Antenna cable
(commercially available)
To antenna
terminal
LC32L400X_EN.indb 3LC32L400X_EN.indb 3 7/8/10 6:45:02 PM7/8/10 6:45:02 PM
To Next Page
Loading...
