Sharp Aquos LC-32M400X - Attaching the Stand and Antenna Connection; Attaching the TV Stand; Antenna Connection

4
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from
being damaged.
1
Confi rm the screws supplied with the TV.
Screw driver
Screw
Soft cushion
CAUTION
• To prevent injury, please do not insert a fi nger or
hand into the opening between TV stand and TV.
Screws (
m
4)
(used in step 3)
2
Insert the stand base to the stand post on
the bottom of the TV. (
1
)
3
Insert and tighten the 4 screws into the 4
holes on the bottom of the stand base. (
2
)
NOTE
• To detach the stand, perform the steps in reverse order.
CAUTION
• To prevent disassemblement of
the stand base, do not unfasten
these two screws.
Antenna connection
Connecting the antenna cable
To enjoy a clearer picture, use an outdoor antenna.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
Room antenna terminal
(75-ohm type)
Antenna cable
(commercially available)
To antenna terminal
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH
THE AC CORD CONNECTED.
LC32M400X_EN_CS2_A5.indd 4LC32M400X_EN_CS2_A5.indd 4 6/9/2011 2:35:02 PM6/9/2011 2:35:02 PM