Sharp AQUOS LC-37A65M

47
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Option”.
2
Press
a
/
b
to select a specifi c adjustment
item among “H-Position”, “V-Position”, “Clock”
and “Phase”.
4
Press
c
/
d
to adjust the item to your desired
position.
5
NOTE
• For resetting all adjustment items to the factory preset
values, press
a
/
b
to select “Reset”, press ENTER, press
c
/
d
to select “Yes”, and then press ENTER.
• Images may not be displayed properly depending on the
settings and/or input signals.
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Option”.
2
Selected item Description
H-Position Centres the image by moving it to the left
or right.
V-Position Centres the image by moving it up or
down.
Clock Adjusts when the image fl ickers with
vertical stripes.
Phase Adjusts when characters have low
contrast or when the image fl ickers.
Adjusting the PC image automatically
This function enables the screen to be automatically
adjusted to its best possible condition when the
analogue terminals of the TV and PC are connected
with a commercially available RGB cable, etc.
Adjusting the PC image manually
Ordinarily you can easily adjust the picture as
necessary to change image position using Auto Sync.
In some cases, however, manual adjustment is needed
to optimise the image.
Connecting a PC
Press
c
/
d
to select “Yes”, and then press
ENTER.
• Auto Sync. starts.
5
NOTE
• Auto Sync. is likely to succeed when an input PC image
has wide vertical stripes (e.g. pattern with high contrast
stripes, or cross-hatched).
It may fail when an input PC image is solid (low contrast).
• Be sure to connect the PC to the TV and switch it on
before starting Auto Sync.
Press
a
/
b
to select “Fine Sync.”, and then
press ENTER.
3
Press
a
/
b
to select “Auto Sync.”, and then
press ENTER.
4
Press
a
/
b
to select “Fine Sync.”, and then
press ENTER.
3
Input Signal
Auto Sync.
H-Position [ 0]
V-Position [ 0]
Clock [ 0]
Phase
Reset
[ 0]
Yes
No
Auto adjustment of image display parameters
V-Position
H-Position
Auto Sync.
Input Signal
Clock
Phase
[ 60]
[ 90]
[ 90]
[ 8]
Reset
+
+
+
+
Image position adjustment, etc.
37A65M_en_g.indd 4737A65M_en_g.indd 47 8/7/2008 12:10:22 PM8/7/2008 12:10:22 PM