Sharp AQUOS LC-40LE814E

9
Attaching the stand unit
• Beforeperformingwork,spreadcushioningoverthesurfaceonwhichyouwillbelayingtheTV.Thiswillpreventitfrombeingdamaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1 Confirm that there are nine screws (four long
screws and five short screws) with the stand
unit.
2 Attach the supporting post for the stand unit
onto the base using the four long screws with
a screwdriver as shown.
Supporting
post
3 Insert the stand into the openings on the
bottom of the TV (hold the stand so it will not
drop from the edge of the base area).
Softcushion
4 Insert and tighten four short screws into the
four holes on the rear of the TV.
5 Attaching the stand cover.
1 Slidethestandcoverintothetwocatcheson
thestandbase.
2 Insertandtightenashortscrewintothehole
onthecentreofthestandcover.
NOTE
• Todetachthestandunit,performthestepsinreverseorder.
• Ascrewdriverisnotsuppliedwiththisproduct.
• Thestandbaseismadeofglass.Therefore,becarefulnotto
dropthestandbaseorapplypressuretoit.
• Donotplaceheavyobjectsonthestandbase.
CAUTION
Thestandismadeoftemperedglass.Readthefollowingprecautionaryinstructionscarefullyanduseitproperly.
• Donotdroporplaceunnecessarystressonthestandwhenassemblingandattachingorremovingit.
• Besuretonotaccidentallyhittheglasspartofthestandwithasharporhardobject,asitmaycausetheglasstobreak.
• Usingtemperedglasswithscratchesforextendedperiodsmayleadtodamageoccurring.Iftherearescratchesonthetempered
glass,donotattempttousethestand.
Preparation