Sharp AQUOS LC-40LE814E

35
Basic adjustment
E Manual adjust
Configurevarioussettingsforeachserviceusingthe
colour(R/G/Y/B)buttons.
Service
no.
Lock
Service
name
Lock CH skip Old LCN
CH skip SortDelete
1 Press a/b to select the desired service.
2 Press the colour button on the remote control
unit corresponding with the item you want to
reconfigure.
• The✔markindicatestheoperationissettoon.Each
timethecolourbuttonispressed,youcanswitchthe
correspondingoperationon/off.
Buttons for “Manual adjust” operation
Lock
PressRbutton.
Whentheserviceislocked,youmustenteryour
PINwheneveryoutunetotheservice.
CH skip
PressGbutton.
Serviceswitha✔markarepassedoverwhen
pressing:r/sontheTVorremotecontrolunit.
Delete
PressYbutton.
Theselectedserviceisdeleted.Ifyouwantto
watchtheserviceyoudeletedonceagain,perform
“Autoinstallation”,“Additionalsearch”,or“Manual
search”.
Sort
PressBbutton.
Theitempositionofservicescanbesorted.
1 Pressa/btoselecttheservicewhose
itempositionyouwanttomove,andthen
press;.
2 Pressa/b tomoveittothedesired
position,andthenpress;.
3 Repeatsteps1and2untilalldesired
serviceitemsaresorted.
Cable
Youcanreconfigurethefollowingsettingswhenyou
select“Cable”intheinitialautoinstallationorthe“Auto
installation”menu.
E Additional search
Usethismenutoaddnewservicesautomaticallyafter
“Digitalsearch”inthe“Autoinstallation”menuhasbeen
completed.Followsteps1to5inSearching for
cable broadcastsonpage14.
E Manual search
Addnewserviceswithinaspecifiedfrequencyband.
Aftersettingtheitemsonthefollowingscreen,theTV
startssearching.
• Refertothetableaboutmenuitemsintherightcolumn
onpage14.
Frequency
Symbol rate
QAM modulation
Search start
MHz
E Manual adjust
Thisfunctionisthesameasin“Terrestrial”.Referto
“Manualadjust”in“Terrestrial”.
H
• Youcanonlyreconfigurethe“Manualadjust”settings.
• Youcanonlysetthe“Lock”settingin“Manualadjust”.
Satellite setting
Beforeselectingthetypeofsearchin“Satellitesetting”,
youneedtoselectthesatellitebroadcast.
SAT2 [Hot Bird 13E]
SAT3 [None]
SAT4 [Turksat]
E Additional search
Usethismenutoaddnewservicesautomaticallyafter
autoinstallationhasbeencompleted.Followsteps1to6
intherightcolumnonpage15.
E Manual search
Addnewserviceswithinaspecifiedfrequencyband.
Aftersettingtheitemsonthefollowingscreen,select
“Yes”from“Searchstart”menu.
Band [Vert/Low]
Frequency
Symbol rate
Search start
Vert/High
Horiz/Low
Horiz/High
Vert/Low
E Manual adjust
Thisfunctionisthesameasin“Digitalsetting”.Referto
“Manualadjust”in“Digitalsetting”.