Sharp Aquos LC-40M500X

9
Programme setup
Digital settings
You can reconfigure DTV services settings
automatically or manually.
1
Press MENU and the MENU screen
displays.
2
Press c/d to select “Setup”.
3
Press a/b to select “Digital Programme
Setup”, and then press ENTER. If you have
already set the password, enter it here.
• See page 13 for setting a password.
4
Press a/b to select the desired menu item,
and then press ENTER.
5
Press c/d to select “Yes”, and then press
ENTER.
H
Auto search (Digital)
Use this menu to add new services automatically
after auto installation has been completed.
H
Manual search (Digital)
Add new services within a specified frequency band.
•
Press
c
/
d
to select the frequency and then press ENTER.
H
Manual adjust (Digital)
Configure various settings for each service using the
Colour (R, G, B) buttons.
Digital Programme Setup]
1
Press a/b to select desired service.
2
Press the Colour button on the remote
control corresponding with the item you
want to reconfigure.
• Each time the Colour button is pressed, you can
switch the corresponding operation on/off.
Buttons for Manual adjust operation
Menu
items
Remote
control
buttons
Description
Lock R
When the service is locked, you must enter
your password whenever you tune to the
service.
CH
Skip
G
Services with “Skip” are passed over when
pressing
r
/
s
in the TV/remote control
unit.
Sort B
The item position of services can be sorted.
Checking Signal
information (Continued)
H
Checking Signal information
Press
a
/
b
to select “Signal information”.
Signal information
Auto search
Manual search
Manual adjust
Antenna power
Signal strength
Signal quality
Current Maximum
Channel number
100
Current Maximum
98
100
98
68
4
Position and align the antenna so that
the maximum possible values for “Signal
strength” and “Signal quality” are obtained.
NOTE
• The values of “Signal strength” and “Signal quality”
indicate when to check the appropriate alignment of the
antenna.
Auto installation
You can run auto installation again, even after setting
up the preset channels.
1
Press MENU and the MENU screen
displays.
2
Press c/d to select “Setup”.
3
Press a/b to select “Auto installation”, and
then press ENTER.
4
If you have already set the password, enter
it here.
• See page 13 for setting a password.
5
Press c/d to select “Yes”, and then press
ENTER.
6
Press
a
/
b
/
c
/
d
to select “DTV”, “ATV” or
“ATV + DTV”, and then press ENTER.
Press a/b to select the desired sound
system, and then press ENTER.
• Sound system is selectable when the signal
search is set to “ATV” or “ATV + DTV” mode only.
You do not need to do anything during the
auto search. Press MENU to exit.
LC40M500X_EN_CS2_A5.indd 9LC40M500X_EN_CS2_A5.indd 9 10-Jun-11 10:22:36 AM10-Jun-11 10:22:36 AM