Sharp AQUOS sense9 - Washing the Product

- 41 -
•
When closing the SIM card/microSD memory card tray, do not get the
rubber seal caught. Also, do not insert sharp objects into gaps around
the SIM card/microSD memory card tray, the earphone/microphone
jack or external connection jack section.
Doing so may damage the rubber seal and cause liquid or dust to get
inside.
•
It is recommended to replace the parts for maintaining the waterproof/
dustproof property (pay service) once every two years regardless of
whether any abnormality is present. For information on part
replacement, contact au Style/au shop near you.
Washing the Product
If any stain, dust, sand, soft drink, etc. is attached to the surface of the
product, gently wipe it off with a cloth and wash the product under a
mild water flow (up to 6 liters/min) of tap water at room temperature (5°C
to 35°C) approximately 10 cm away from the faucet or shower head.
Hold the SIM card/microSD memory card tray so that it does not open,
and wash the product with your hands without using a brush or sponge.
After washing the product, drain water off and then use the product.
•
Make sure that the SIM card/microSD memory card tray is securely
closed before washing the product.
•
Do not wash the product with a washing machine or an ultrasound
bath.
•
The earphone/microphone jack section and external connection jack
section are especially subject to stain such as dust or sand adhesion.
Wash away stain carefully so as not to keep it remaining in the
sections. Also, after washing it away, make sure the sections get
sufficiently dried off before using the product. Using the product with
sand or water drops remaining in the jack sections may cause fault.
•
When cleaning the earphone/microphone jack section and external
connection jack section, do not use tools such as a cotton swab or jam
a cloth into the jack sections. Doing so may cause impairment of
waterproof/dustproof property etc., resulting in fire, burns, or a fault.
•
Never put the product in a microwave oven for drying it. Doing so may
cause the internal battery to leak liquid, overheat, rupture or ignite.
Also, doing so may cause the product to overheat, emit smoke, ignite
or cause destruction of circuit components.
•
Do not expose the product to hot air from a hair dryer or leave it in a
high temperature environment for drying it. Doing so may cause the
product to deform, discolor, get out of order, etc.