Data communication
Infrared communication
When using infrared communication
z
Face the infrared ports of the receiver's and sender's
devices with each other and set the distance between
them to approximately 20 cm or less as shown.
15°
15°
Infrared port
Approx. 20 cm or less
z
The handset infrared communication function complies
with IrMC™ 1.1 standard. However, some data may not
be sent or received even when the other party's device
complies with IrMC™ 1.1 standard.
z
You can send and receive phonebook entries, still
pictures, videos, etc.
z
Infrared communication is not available in Airplane
mode.
z
Entering the authentication password is required for
sending all data. The authentication password is a
password exclusive to infrared communication. Before
starting data communication, the sender and receiver
must enter the same user-specified four-digit code.
z
If either of the infrared ports is dirty, infrared
communication will become difficult. Take care not to
scratch the ports, and wipe off any dirt with a soft
cloth.
z
Infrared communication may not function properly in
areas exposed to direct sunlight, directly under
fluorescent lights or near equipment using infrared
signals.
z
Keep the infrared ports facing each other and do not
move the devices until sending and receiving of data
are completed. Do not close the handset.
z
It may take time to communicate depending on the
data space or other party's device.
158
Data communication
To Next Page
Loading...
