Sharp AQUOSLC-42GX3H - Before Turning on the Power

Preparation
8
1
Before turning on the power
Notes on installing the TV
• Avoid direct sunlight and place the TV in a well-ventilated location.
• Place the TV in a level location.
• Do not turn on the power of the TV before connecting the AC cord.
Cable clamp
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
Bundling the cables
1 Insert the cable clamp in the hole on the TV as shown.
4
AC cord
Connecting the AC cord
AC outlet
• Place the TV close to the AC outlet, and keep the power plug within reach.
• Disconnect the AC cord from the AC outlet if the TV will not be used for a long period of time.
TV (rear view)
Connecting the antenna cable
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of
connections that are used for coaxial cable.
Detach the terminal cover of
1
and
2
.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
Room antenna terminal
(75-ohm type)
Antenna cable
(commercially available)
To antenna
terminal
Connecting external devices
See pages 9 to 10 for connecting external equipment, such as a VCR and DVD player.
2
3
1
2
1
Unfasten the upper side.
2
Pull from the lower side.
2 Detach the cable cover attached to the TV.
1
Insert the lower side.
2
Attach the upper side.
3 Bundle the cables and
attach the cable cover.
52GX3H_en_b.indd 852GX3H_en_b.indd 8 2007/10/25 10:23:222007/10/25 10:23:22