Sharp AQUOSLC-42GX3H - Mounting the TV on the Wall; Removing the Stand; Affi Xing the Protective Cover

Appendix
NOTE
• To attach the stand, perform the above steps in reverse order.
• As the TV is very heavy, be careful when moving it.
Mounting the TV on the wall
Remove the protective cover
from the backing.
Attach the stand protective covers
(supplied with the product).
12
Affi xing the protective cover
This TV type is designed to be hung on a wall. Affi x the supplied protective cover to the TV cabinet hole by following the
instructions below.
3
Removing the stand
For wall mounting with the optional bracket (AN-52AG4) remove the stand.
Before setting TV on the wall.
• Remove the connected cables (DVD, VCR, etc) from the terminals.
• Detach the four caps at the 4 locations on the rear of the TV.
Firmly affi x the protective cover to
the cabinet hole on the bottom of
the TV.
50
1
2
1
Detach the stand from the TV. (Hold the stand so
it will not drop from the edge of the base area.)
2
Use the protective cover to prevent dust from
entering the underside of TV where the stand has
been detached. (See page 50)
NEIZJAGRU
Set the TV on the wall.
1
Unfasten the four screws used to secure the
stand in place.
2
Attach the wall mount brackets.
3
52GX3H_en_h.indd 5052GX3H_en_h.indd 50 2007/10/25 10:26:412007/10/25 10:26:41