9
INSTALLING THE SOFTWARE
11
When the interface selection screen 
appears, select "Parallel" and click the 
"Next" button.
12
Select the printer port and click the 
"Next" button.
Select "LPT1" for the printer port. 
13
When the model selection window 
appears, select model name of your 
machine and click the "Next" button.
For the model name of your machine, see 
"PART NAMES AND FUNCTIONS" in the 
operation manual for copier.
14
Click the "Yes" button.
15
When "The installation of the SHARP 
software is complete" appears, click 
the "OK" button.
16
Begin the installation of the PC-FAX driver 
(if "PC-FAX Driver" was selected in Step 7).
Follow the on-screen instructions.
•
When the model selection window appears, 
select model name of your machine.
• During installation of the PC-FAX driver, 
you will be asked to select the port. If 
you are using the parallel port, select 
"LPT1" and continue the installation.
Click the "Finish" button when the message 
informs you that setup is successful.
17
When the "Finish" screen appears, 
click the "Close" button. 
When "After Windows system restarts, 
connect the interface cable to the PC" 
appears, click the "OK" button.
18
Turn off the power of the machine and 
your computer, and connect the 
machine to your computer with the 
parallel cable. (p. 10)
After connecting the machine to your 
computer, turn on the power of the 
machine and then start up your computer.
This completes the installation of the software.
•
If you installed the printer driver, configure the 
printer driver settings as explained in 
"CONFIGURING THE PRINTER DRIVER" (p. 11).
If "LPT1" does not appear, another printer 
or peripheral device is using LPT1. In this 
case continue the installation, and after the 
installation is finished, change the port 
setting so that the machine can use LPT1. 
This procedure is explained in "Another 
printer is using the parallel port (when 
using a parallel cable)" on page 14.
Note
After the installation, a message 
prompting you to restart your computer 
may appear. In this case, click the "Yes" 
button to restart your computer.
Note
!!install_ar230270.book  9 ページ  2003年7月10日 木曜日 午後11時15分