9
INSTALLING THE SOFTWARE
Installation in Windows 98/Me/NT 4.0/2000 (Parallel cable)
1
The parallel cable must not be connected
to the machine. Make sure that the cable
is not connected before proceeding.
If the cable is connected, a Plug and Play
window will appear. If this happens, click
the "Cancel" button to close the window
and disconnect the cable.
2
Insert the "Software CD-ROM" into your
computer's CD-ROM drive.
3
Double-click "My Computer" ( ), and
then double-click the [CD-ROM] icon
().
4
Double-click the "Setup" icon ( ).
5
The "SOFTWARE LICENSE" window will
appear. Make sure that you understand
the contents of the license agreement,
and then click the "Yes" button.
6
Read the message in the "Welcome"
window and then click the "Next" button.
7
Click the "Custom" button.
8
Click the "Printer Driver" button.
Before installing the software, be sure to
click the [Display Readme] button and view
the detailed information on the software.
9
Click the "Next" button.
If you are using Windows NT 4.0, go to step 12.
For users of Windows NT 4.0
The CD-ROM does not include software for Windows NT 4.0.
Contact your dealer or nearest authorized service representative if you want the software for
Windows NT 4.0.
Note
The cable will be connected in step 17.
You can show the "SOFTWARE
LICENSE" in a different language by
selecting the desired language from
the language menu. To install the
software in the selected language,
continue the installation with that
language selected.
Note
Note
!ar_m250_310_5600series_sec_splcsetup.book 9 ページ ２００７年２月９日 金曜日 午前９時４６分
To Next Page
Loading...
