Sharp AR-M257 - TROUBLESHOOTING AND MAINTENANCE

57
USER SETTINGS
4
EXECUTING A JOB PROGRAM
1
Press the [ ] key.
2
Touch the program number key of the
desired program.
The job program will be
executed. A number for
which no job program
has been stored cannot
be selected.
3
Place the original, check the original
size, and then set the number of
copies and any other desired copy
settings not stored in the program.
When finished, press the [START] key
().
DELETING A STORED JOB PROGRAM
1
Press the [ ] key.
2
Touch the [STORE/DELETE] key.
3
Select the program number of the
program to be deleted.
If a number key for which
no job program has been
stored is selected, the
proceed to step 4 on the
previous page (for
storing a job program).
4
Touch the [DELETE] key.
The selected program will
be deleted and you will
return to the screen of step
3. If the [CANCEL] key is
touched, you will return to
the screen of step 3
without deleting the
program.
If you are finished deleting programs, touch the [EXIT]
key in the screen of step 3 to exit.
ACC.#-C
S
JOB PROGRAMS
PRESS PROGRAM NUMBER.
RECALL
ACC.#-C
ACC.#-C
S
NUMBER.
ECALL STORE/DELETE
EXIT
STORE/DELETE
RECALL STORE/DELET
A JOB PROGRAM HAS BEEN ALREADY STORED.
STORE ANOTHER PROGRAM?
CANCEL DELETE STORE
!Andromeda_copy_sec.book 57 ページ ２００６年１２月１８日 月曜日 午前９時３５分