SPECIAL FUNCTIONS
26
TRANSMITTING A DIVIDED ORIGINAL (DUAL PAGE SCAN)
When an open book is scanned and transmitted, you can use this function to divide the two open pages of the book
into two separate pages.
This function can only be used when the original is scanned using the document glass.
Selecting Dual Page Scan
Follow the steps below and then send the image.
1
In scanner mode, touch the [SPECIAL
MODES] key.
If the address book
screen appears, touch
the [CONDITION
SETTINGS] key to
display the condition
settings screen (page
11).
2
Touch the [DUAL PAGE SCAN] key.
The [DUAL PAGE
SCAN] key is
highlighted.
To cancel the selection,
touch the key once
again so that it is not
highlighted.
3
Touch the [OK] key.
You will return to the
screen of step 1.
4
Place the original on the document glass,
and perform the transmission operation.
If you have more originals to scan after pressing
the [START] key and scanning the first original,
change originals and repeat scanning until all
originals have been scanned. When finished,
press the [READ-END] key that appears in the
message display. (See step 23 - 25 of "Using the
document glass" on page 15
.)
Book or sheet original
When page division is set,
the original is divided
into two pages when
scanned into memory
Transmitted out as
two separate pages
Your machine The other machine
Transmission to
other machine
[Example]
Scanned original size
A3
Transmitted document
Two A4 pages
To Next Page
Loading...
