Sharp AR-M355N

Quick Reference Guide: AR-M355N/M455N
Simulation List (Pg. 7 of 10)
Simulation List (Main/Sub) (cont’d)
Used to check the operation of the printer section (self-print operation). (The print pattern, the paper feed mode, the print mode,
the print quantity, and the density can be optionally set).
164
Used to adjust the white plate scan start position for shading. (Document table mode.)7
Used to execute shading.2
Used to check the result of shading correction. (The shading correction data are displayed.)163
Used to delete document filing data. (The management area (standard folder, user folder) is cleared.)11
Used to delete a job complete list (also to delete job log data).10
Used to format the hard disk (the system area excluded).8
Used to check the operation soft the hard disk. (/The result of the self-diag operation of the SMART function is printed out.)7
Used to check the operations of the hard disk. (The self-diag operation of the SMART function I executed.6
Used to check the operations of the hard disk (read/write). (All areas check.)3
Used to check the operation of the hard disk (read/write). (Only in the model with a disk installed). (Partial check.)2
Used to format the hard disk.162
Used to adjust the laser power (absolute value) in the printer mode.4
Used to adjust the laser power (absolute value) in the FAX mode.3
Used to adjust the laser power (absolute value) in the copy mode.2
Used to check the operation of the scanner (write) unit (LSU).161
Used to check the MFP control (DRAM) operations (read/write).160
Used to transfer the MFP controller data. (Used to repair the PWB.)156
Used to set the specifications of the controller operations. (MFP control PWB).3
Used to set the specifications of the scanner control operations. (Scanner control PWB).2
Used to set the specifications of the engine control operations. (PCU-PWB).155
12