SCANNING SETTINGS (ORIGINAL SIZE, EXPOSURE, RESOLUTION, AND FILE FORMAT)
23
SELECTING THE EXPOSURE
You can adjust the exposure manually to match the type of original. After loading the original in scanner mode, follow
the steps below. The default setting for the exposure is "AUTO".
Change the exposure
1
Touch the [EXPOSURE] key.
2
Select [AUTO] or [MANUAL].
If you selected [AUTO],
the exposure will be
adjusted automatically.
If you selected
[MANUAL], touch the
or key to adjust
the exposure. (For
darker contrast, touch
the key. For lighter
contrast, touch the
key.)
3
Touch the [OK] key.
You will return to the
initial screen.
SELECTING THE RESOLUTION
The resolution for scanning an original can be selected. Load the original in scanner mode and then follow the steps
below. The default setting for the resolution is "300x300dpi" (E-MAIL/FTP mode) or "STANDARD" (Internet-Fax
mode).
Change the resolution
1
Touch the [RESOLUTION] key.
2
Touch the desired resolution key.
E-MAIL/FTP mode
Four selections are available for the resolution.
Touch the desired resolution key depending on the
original to be scanned.
The selected key is highlighted.
NOTES
The default value of exposure can be set using the
key operator program, "Default exposure settings"
(page 56
).
When using the automatic document feeder, the
exposure setting cannot be changed once
scanning has begun.
To Next Page
Loading...
