Sharp AR-M451N

SPECIAL FUNCTIONS
30
3
Enter the X dimension (width) and Y
dimension (length) of the original with the
keys.
OX (width) is initially selected. Enter X and then
touch the Y ( ) key to enter Y.
OTo return the X and Y values to the initial
settings configured in the key operator
programs, touch the [SIZE RESET] key. (key
operator's guide "CARD SHOT SETTINGS"
on page 15)
OTo have the image enlarged or reduced by a
suitable ratio based on the entered original
size and the send size so that the front and
back sides fit into the transmitted paper size ,
touch the [FIT TO SEND SIZE] key.
OTo cancel the card shot function, touch the
[CANCEL] key.
4
Touch the outer [OK] key.
You will return to the
screen of step 1 and a
card shot icon will
appear next to the
[EXPOSURE] key.
5
Place the original on the document glass.
Place the front side of
the original face down
and close the document
cover.
6
Follow steps 4 through 22 of "BASIC
TRANSMISSION METHOD" (pages 12
to
14).
7
Press the [START] key.
The front side of the card
is scanned.
8
Place the back side of the original face
down on the document glass. (see step 5)
9
Press the [START] key.
The back side of the
card is scanned.
10
Touch the [READ-END] key.
A beep will sound to inform you that the
transmission was stored.
SIZE RESET
CANCEL
OK
OK
FIT TO
SEND SIZE
SIZE RESET
CANCEL
OK
OK
FIT TO
SEND SIZE
NOTE
To cancel card shot...
Press the [CA] key.