KEY OPERATOR PROGRAMS
54
5
Touch the [OPERATION SETTINGS] key,
the [E-MAIL/FTP SETTINGS] key or the [I-
FAX SETTINGS] key, depending on the
program you wish to use.
6
Make desired settings for the selected
program.
Select the desired program from among the
programs listed on the previous page
.
Detailed descriptions for program settings start on
the next page
.
7
Touch the [OK] key to return to the screen
of step 5.
If you wish to use
another program, touch
the key for that program
in the screen of step 5.
8
Press the [CA] key to exit the program.
Supplementary explanation of key operation
for key operator programs
A The name of the program category or particular item to be set will appear on the touch key. The displayed item
is selected by touching the key.
B Check mark boxes are touch keys that show the status of selections. A box with a check mark means the
function is "on" (enabled) and an unchecked box means the function is "off" (disabled). The on/off status
changes each time the box is touched.
C If the settings continue on the following screen(s), touch the and keys to move back and forth through
the screens. To return to the category selection screen, touch the [OK] key.
D The currently set numerical value is displayed.
E Numerical values can be set by touching the and keys.
15
(1-15)
A
KEY OPERATOR PROGRAMS
OPERATION SETTINGS
1/2
INITIAL RESOLUTION SETTING
THE NUMBER OF FILE NAME/
SUBJECT KEYS DISPLAYED SETTING
MUST INPUT NEXT ADDRESS
KEY AT BROADCAST SETTING
OK
DEFAULT DISPLAY SETTINGS
THE NUMBER OF DIRECT ADDRESS/
SENDER KEYS DISPLAYED SETTING
B
C
DE
6
6
These keys and indicator are
available on setting screens that
require the entry of numerical values.
To Next Page
Loading...
