1 Press the TIMER ON ( ) button.
2 The TIMER ON indicator will blink. Press the TIME
ADVANCE or REVERSE button to set the desired
time. (The time can be set in 10-minute incre-
ments.)
3 Point the remote control at the signal receiver
window on the unit and press the TIMER SET
(SET/C) button.
» The yellow TIMER lamp (
) on the unit will
light.
» The unit will generate a beep when it receives
the signal.
4 Select the operation condition.
» The unit will turn on prior to the set time to allow
the room to reach the desired temperature by
the programmed time. (Awaking function)
E-10
TIMER ON
2
1
3
+-
MODE
SWING
FAN
AM
1H
SET/C
PM
AM
TIMER OPERATION
NOTES:
»You cannot programme the TIMER ON and TIMER OFF to operate the unit at different
temperatures or other settings.
» Either timer can be programmed to activate prior the other.
COMBINED USE OF ON AND OFF TIMERS
You can use the ON and OFF timers in combination.
Example:
To stop operation at 11:00 p.m. and resume operation
(with the same mode and temperature settings) to bring
the room temperature to the desired level by 7:00 a.m.
1 Set the TIMER OFF to 11:00 p.m. during operation.
2 Set the TIMER ON to 7:00 a.m.
The arrow ( or ) between the TIMER ON indicator and
the TIMER OFF indicator shows which timer will activate
first.
To Next Page
Loading...
Need help?
General
