ENGLISH
1 Press the TIMER OFF ( ) button.
2 The TIMER OFF indicator will blink; press the
TIME ADVANCE or REVERSE buttons to set
the desired time. (The time can be set in 10-
minute increments.)
3 Point the remote control at the signal receiver
window on the unit and press the TIMER SET
(SET/C) button.
» The yellow TIMER lamp ( ) on the unit will
light.
» The unit will generate a beep when it re-
ceives the signal.
NOTE:
Before setting the timer, make sure the clock is properly set with the current time.
E-9
TIMER OPERATION
TIMER OFF
When the TIMER OFF mode is set, the
temperature setting is automatically adjusted
to prevent the room from becoming
excessively hot or too cold while you sleep.
(Auto Sleep function)
COOL/DRY MODE:
» One hour after the timer operation begins,
the temperature setting rises 1°C higher
than the original thermostat setting.
HEAT MODE:
» One hour after the timer operation begins,
the temperature setting drops 3°C lower
than the original thermostat setting.
NOTES:
»»
»»
» The Auto Sleep function will not activate
during the FAN ONLY mode.
»»
»»
» The temperature setting cannot be ad-
justed during the FAN ONLY mode.
2
3
1
TO CANCEL TIMER MODE
Press the TIMER CANCEL (SET/C) but-
ton.
» The yellow TIMER lamp (
) on the unit
will turn off.
» The current clock time will be displayed
on the remote control.
NOTE:
» If both TIMER ON and TIMER OFF are
set, the TIMER CANCEL button cancels
both settings.
TO CHANGE TIMER SETTING
Cancel the TIMER seting first, then set it
again.
TIPS ABOUT TIMER OFF OPERATION
To Next Page
Loading...
Need help?
General
