Sharp BD-HP90S

Player setup location
This player can be used in a horizontal or vertical
position depending on the installation location.
Using the player in a horizontal positionE
Using the player in a vertical positionE
Switch the remote control sensor to “Front” or “Top”
depending on the installation location.
FRONT
TOP
Installing the vertical stand
When using the player in a vertical position, install the
supplied stand.
Match the screw hole of the player and the
stand.
1
Secure the stand to the player.
Bundle the cables.
2
3
Securing the player to a TV stand, etc.
To prevent the player from falling, the stand can be
secured to a TV stand, etc.
Using a screw (commercially available), attach the screw
to the hole of the stand to secure the player.
19
Introduction
Remote control sensor “Front”
Remote control
sensor “Front”
Remote control
sensor “Top”
The screw is attached
on the stand.
Screw hole
Pass the cables
through the stand.
Screw (diameter:
approx. 3 mm)
TV stand, etc.
Selector switch for
Remote control sensor