A30092, R-880 O/M
5
CONNECTING PLUG
You must connect a 3 pin plug to the power supply cord.
WARNING - THIS APPLIANCE MUST BE EARTHED.
If you are unsure how to do this get help from an electrician.
IMPORTANT - The wires in the mains cable are colour coded as follows:
green and yellow stripes = earth
blue = neutral
brown = live
The wire terminals or screws in your plug may not be marked in the same way as the wires, so to be quite sure
you have wired the plug properly you should connect the wires as follows:
green and yellow striped wire to the terminal marked
Eor
or
coloured green or
coloured green and yellow
blue wire to the terminal marked
Nor
coloured black or
coloured blue
brown wire to the terminal marked
Lor
coloured red or
coloured brown
Make sure the terminal screws are properly tirhtened and the power supply cord is held tightly by the cable grip
where it enters the plug.
Link most appliances in your house, your oven must be connected to a single phase 220 volt, 50 Hz alternating
current supply. If you have any doubts about your electrical supply ask a qualified electrician.
If you do not make the proper electrical connections you might damage your microwave oven or injure yourself.
Neither SHARP nor the supplier will be liable if this happens.
R880 O/M,02-15 04.3.2, 3:22 PM5
To Next Page
Loading...
Need help?
General
