04/2/23 CD-ES600V(Z)E5.fm
E-43
ENGLISH
TINSZA060AWZZ
CD-ES600V
Advanced Features
! Headphones
"
Before plugging in or unplugging the headphones, reduce the
volume.
"
Be sure your headphones have a 3.5 mm (1/8") diameter plug
and the impedance is between 16 ohms and 50 ohms. The rec-
ommended impedance is 32 ohms.
"
Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
! General
! Video CD
Symptom Possible cause
"
The clock is not set to the
correct time.
"
Did a power failure occur? Reset
the clock. (Refer to page 15.)
"
When a button is pressed,
the unit does not respond.
"
Set the unit to the power stand-
by mode and then turn it back on.
"
If the unit still malfunctions, reset
it. (Refer to page 45.)
"
No sound is heard.
"
Is the volume level set to "0"?
"
Are the headphones connected?
"
Are the speaker wires discon-
nected?
"
Is the karaoke mode set to "L-
CH", "R-CH" or "V-CANCEL"?
Symptom Possible cause
"
The picture is not dis-
played during playback.
"
Is the TV unplugged?
"
Is the unit connected improperly?
"
Is the input selector on the TV set
to other than "VCR"?
"
Is the unit being played without
selecting video CD?
"
The picture quality is poor,
or it is distorted.
"
Is the disc very dirty?
To Next Page
Loading...
