CD-ES600/CD-ES66
SERVICE MANUAL
No. S2404CDES600/
SHARP CORPORATION
CONTENTS
Parts marked with " " are important for maintaining the safety of the set. Be sure to replace these parts with specified ones for
maintaining the safety and performance of the set.
This document has been published to be used
for after sales service only.
The contents are subject to change without notice.
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications ................................................. 1-1
[2] Names of parts............................................... 1-2
CHAPTER 2. ADJUSTMENTS
[1] Mechanism section ........................................ 2-1
[2] Tuner section ................................................. 2-1
[3] CD section...................................................... 2-2
[4] CD Changer mechanism section ................... 2-3
CHAPTER 3. MECHANISM BLOCKS
[1] Caution on disassembly ................................. 3-1
[2] Removing and reinstalling the main parts ........ 3-4
CHAPTER 4. DIAGRAMS
[1] Block diagrams............................................... 4-1
CHAPTER 5. CIRCUIT DESCRIPTION
[1] Notes on schematic diagram.......................... 5-1
[2] Types of transistor and LED........................... 5-1
[3] Waveforms of CD circuit ................................ 5-2
[4] Voltage ........................................................... 5-3
CHAPTER 6. CIRCUIT SCHEMATICS AND PARTS
LAYOUT
[1] Schematic diagram........................................6-1
[2] Wiring side of P.W.Bord ...............................6-10
CHAPTER 7. FLOWCHART
[1] Troubleshooting .............................................7-1
CHAPTER 8. OTHERS
[1] Function table of IC .......................................8-1
[2] FL Display.................................................... 8-11
Parts Guide
MINI COMPONENT SYSTEM
CD-ES600
MODEL
CD-ES66
MODEL
CD-ES600 Mini Component System consisting of CD-ES600
(main unit) and CP-ES600 (speaker system).
CD-ES66 Mini Component System consisting of
CD-ES66 (main unit) and CP-ES66 (speaker sys-
tem).
In the interests of user-safety the set should be restored to its
original condition and only parts identical to those specified be
used.
To Next Page
General
