Sharp CD-JX20X(GY) - Page 8

-
BEAT CANCEL
4-
n APSS spacing
n Recording from the built-in radio
IT une into the desired station.
2 Load a cassette into the TAPE 2 cassette compartment.
3 Set the REVERSE MODE switch to z to record on only
one side, or to ZJ for continuous recording on both sides.
4 Press the REC PAUSE (WI) button,
0 The REC PAUSE indicator lights up and the PLAY indicators flash.
5 Press the PLAY k) button to record side A, or the PLAY
(4) button to record side B.
0 For continuous recording of both sides, begin on side A. Recording
stops automatically at the end of side 6.
Beat cancel switch (on the rear panel)
If beating noise occurs with AM, set the BEAT CANCEL switch to A,
B or C, whichever gives the best reception.
n Erasing recorded tapes
APSS requires blanks of 4-5 seconds between selections to function
properly. Make the blanks as follows.
1 Press the REC PAUSE (all) button when the selection
being recorded ends.
2 Press the AUX button.
Note:
Du not connect anything to the AUX sockets.
3 Press the PLAY (b) or PLAY (4) button of which its indi-
cator is lit, let the tape run for 4 - 5 seconds, then press
the REC PAUSE (al) button again.
4 Press the TUNER button.
5 Start the next recording.
1 Load the tape to be erased into the TAPE 2 cassette com-
partment.
2P
ress the AUX button.
Note:
Du not connect anything to the AUX sockets.
3 Set the REVERSE MODE switch to zz to erase only one
side and to ZJ to erase both sides.
4 Press the REC PAUSE (Oil) button, then press the PLAY
(k) button to erase side A of tape, or the PLAY (4) button
to erase side B.
-IO-