Sharp DV-3750S - Page 16

(7) On/Off Timer Button [3
When the time you have set using the On/Off Timer
Button has elapsed (anywhere from 10 min. to 12
hr. 50 min.), the set will automatically either turn
iiself on or enter standby mode.
<How to Set the On Timer>
1. Press the On Timer button.
2. The previously set time will be displayed in
yellow for about 5 sec. al the lower right of your
screen. (The previously set time is stored in
memory.)
. If your wish to reset the timer to the previously
set time, then setting is now complete.
. If you wish to set the timer to a time different
from the previously set time, then press the On
Timer button again while the time is still being
displayed on the screen.
. Each time you press the button, the display will
change as shown.
*** 50.00 — 0.10 > ----— 12.50 — 0.00 eel
L_Prev.
6. In order to know when the ON-TIMER
programming has been run properly, when the
TV is in the standby mode, the LED indicator
remain iluminated in ORANGE.
GIGI DRISA
Notes:
1. If the previously set time is “0.00”, or if you
are setting the timer for the first time since
buying your set, begin at “0.00”.
. If the Main Power is turned off after the On
Timer has been set, the On Timer will be
On
Screen
Display
canceled.
(In
this
event,
the
On
Timer
.
If,
after
setting
the
On-Timer,
the
On-Timer
operates
after
9
hours)
button
is
pressed
again
while
the
set
is
turned on, then the timer will be reset.
The colour of LED indicator
GREEN — ORANGE