Sharp DW-209EX - Control Panel; Dehumidification Mode

9
FAST
STANDARD
GENTLE
AUTO DRY
ROOM DRY
CONTINUOUS
CLEAN AIR
DRY
FAN SPEED
DEHUMID
SETTINGS
DRY CLOTHES
SETTINGS
ON/OFFHIGH LOW
(Operation Procedure 10)
(The liquid-crystal indicator shows all indications for
explanation.)
Dehumidification mode
AUTO DRY
Controls humidity automatically between 55 and
60%.
ROOM DRY
Controls humidity automatically at about 50%.
CONTINUOUS DRY
Continuous dehumidifying operation by control-
ling the volume of airflow at “medium” when
room temperature is 15°C or more and at “turbo
(HIGH)” when 15°C or less.
CLEAN AIR
CLEAN AIR function is operated independently.
DEHUMID SETTINGS
button
(
11, 12)
Switches to dehumidifying operation
mode
Fan speed/HIGH
indicator
Fan speed/HIGH, ON/OFF
button
DRY CLOTHES
SETTINGS button
(
10, 12)
Switches to DRY CLOTHES mode.
Temperature/humidity in-
dicator
Indicates room temperature and humidity
(around the unit).
Comfort indicator (
13)
Indicates comfort levels in a room.
Airflow volume indicator
Indicates airflow volume.
DRY CLOTHES mode
FAST
CONTINUOUS DRY operation, putting the
airflow volume at HIGH.
STANDARD
CONTINUOUS DRY operation, putting the
airflow volume at MEDIUM.
GENTLE
CONTINUOUS DRY operation, putting the
airflow volume at LOW.
TIMER indicator
The volume of airflow can be
switched only when operating in the
dehumidifying mode.
Defrosting indicator (
15)
Indicates “Defrosting”.
ON/OFF TIMER
indicator
( 14,15)
“ON” indicates the time interval un-
til operation starts, and “OFF” in-
dicates the time interval until op-
eration stops.
High-temperature
indicator
( 5)
When the temperature inside the
unit reaches an abnormally high
temperature, operation stops for
safety and the indicator blinks.
Control panel
Timer setting
button
( 14,15)
Sets the time to start or stop op-
eration and can be set between
1 to 9 hours.
AUTO→HIGH
Fan speed/LOW
indicator
Fan speed/LOW, ON/OFF
butto
n
AUTO→LOW
Full tank indicator
Operation indicator
( 10, 11)
The indicator lights when the
unit is in operation.
The indicator blinks under timer-
input setting and lights after set
up is completed.
Power ON/OFF
button
( 10, 11)
Controlling operation of the unit
by ON/OFF.